The following are some of the features that are available on our laminators.
|
The automatic cutoff knife is used to greatly speed up the lamination process. When the knife is in operation the glass will stop very shortly, the knife will cross cut, and the cycle will continue. The cut off knife is not a standard item but we strongly recommend this option above 48 ‘ product width .
|
 Automatic Cutoff Knife |
 Touch Screen |
Programmable touch screen can be programmed with a variety of inputs and outputs. This permits visual status messages to facilitate the monitoring and debugging of the laminator.
|
|
The laminator glass in-feed skews the glass sheet against a reference edge guiding system providing perpendicular and parallel references in the laminator flow line |
 Edge Guide |
|
1
The glass start at 3” away from the edge guide |
2
The glass is now 1” away from the edge guide |
3
The glass is now parallel with the edge guide |
 Support for material role. |
Using these supports on the material shaft allows you to load new material roles quickly and easily. Loading time for a fresh role is between 2-5 min.
|
 Support for material role. |